Thorp Air Command - T18.net
http://t18.net/thorpforum/

315 Main Beam Fitting - Drawing Question
http://t18.net/thorpforum/viewtopic.php?f=10&t=9133		 Page 1 of 1
Author:  stevejr20@pm.me [ Sun Feb 09, 2025 7:14 pm ]
Post subject:  315 Main Beam Fitting - Drawing Question
Greetings - I need some assistance on interpreting this drawing. The .62R red circled seems incorrect given this is a full scale drawing when compared with the .820R shown. Unfortunately this drawing is no longer to scale due to photo copying (top dimension is actually 7.750 with the ruler) so I can't simply use a drill bit to gauge. This radius looks like a clearance relief so want to get it right.

Thanks
Image
Author:  bfinney [ Mon Feb 10, 2025 1:49 am ]
Post subject:  Re: 315 Main Beam Fitting - Drawing Question
Checking my drawing I believe it should be 0.062"R. It scales pretty close to the #30 holes. NOTE: my drawing does not scale exactly either.
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/