Thorp Air Command - T18.net
http://t18.net/thorpforum/

Ken Brock spinner backplate
http://t18.net/thorpforum/viewtopic.php?f=19&t=8238
Page 1 of 1

Author:  James Grahn [ Wed Jun 20, 2018 8:54 am ]
Post subject:  Ken Brock spinner backplate

Ok guys, I've finally been bombarded enough with requests to have Ken Brock style spinner backplates made. They are used on CS props and have a 2.5 inch offset toward the rear. I'll pay to have a Buck made and run a batch.
Here's what I need. Does anyone have one that is not installed that I can borrow for a while? I need to send an exact piece to my spinner so he can make a buck.
Thanks
Cubes
BTW, Twin Comanche spinners only have about .5" offset and will not work.

Author:  James Grahn [ Sat Jun 23, 2018 10:47 am ]
Post subject:  Re: Ken Brock spinner backplate

Found one. Thx.
Cubes

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/