| Thorp Air Command - T18.net http://t18.net/thorpforum/ |
|
| Ken Brock spinner backplate http://t18.net/thorpforum/viewtopic.php?f=19&t=8238 |
Page 1 of 1 |
| Author: | James Grahn [ Wed Jun 20, 2018 8:54 am ] |
| Post subject: | Ken Brock spinner backplate |
Ok guys, I've finally been bombarded enough with requests to have Ken Brock style spinner backplates made. They are used on CS props and have a 2.5 inch offset toward the rear. I'll pay to have a Buck made and run a batch. Here's what I need. Does anyone have one that is not installed that I can borrow for a while? I need to send an exact piece to my spinner so he can make a buck. Thanks Cubes BTW, Twin Comanche spinners only have about .5" offset and will not work. |
|
| Author: | James Grahn [ Sat Jun 23, 2018 10:47 am ] |
| Post subject: | Re: Ken Brock spinner backplate |
Found one. Thx. Cubes |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|