Thorp Air Command - T18.net

I desire to not install the rudder cables in the tunnel. The stabilator trim and flaps will be electric and want to make the center tunnel smaller so there is more room in the cockpit and desire to run the rudder cables outside of the seats also. Any information and/or drawings of this rudder pedal modification and the creation of a smaller rounder center tunnel? Thank you so much for any response. Tom

I think that mod may be somewhere in all the newsletters, but I dont know where. Hopefully it is. Here is a link to all the newsletters. Happy hunting. Sorry I cant point you to the exact newsletter.

http://thorp18.com/index.php?option=com ... Itemid=159

Thank you so much. I will start to look for the information.

I spent a few minutes looking through the newsletters and I couldnt find anything. If you are successful in finding a write up about it, please post it back here. Good luck

Thank you for looking. I see in Newsletter #73 page 17 a letter from a builder that states " I outboarded the rudder pedals like Bob Dials's drawing." so there is a drawing out there. Anybody have any info about Bob Dial? Thanks.

I believe that Gary Green had posted photos of his installation of outboard rudder cable on the forum. The search function is your friend

_________________
Bruce Finney
N18JF T-18C #262
Yelm, WA USA

Bruce - Thank you. I searched some more but still have not found anything about outboarding the rudder cables. I thought there would be tons of info on this subject. I will continue to research the subject. Thanks again. Tom

See newsletter #47 please ...

http://thorp18.com/thorp_newsletter_archive/NL47.pdf

_________________
Lee Walton
Houston, TX
N51863,N118LW
KEFD

Incidentally, I have the Doc’s plane referred to in this newsletter.
It is a round back. One the my future projects.
Cubes