Thorp Air Command - T18.net

Supporting Owners, Builders and Pilots of the Thorp T-18 and its variants.
It is currently Mon Dec 23, 2024 9:24 am

View unanswered posts | View active topics


Board index » Thorp T-18 » Fuselage & Empennage

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 2 of 2
  [ 17 posts ]  Go to page Previous  1, 2
  Print view Previous topic | Next topic 
Author Message
Bill Williams
PostPosted: Sat Dec 29, 2012 7:53 am 
Cutting a hole in this area requires more than just cutting a hole, be it round or square. This is a carry through box for the tail feathers and requires a little more than just cutting a hole. There are approved methods to do this, rivets and rivet spacing, doublers, etc.
Top
  
 
Ryan Allen
PostPosted: Sat Dec 29, 2012 9:24 pm 
Hero Member
Hero Member
User avatar

Joined: Wed Oct 21, 2009 6:10 pm
Posts: 1123
Images: 0
Location: Louisiana
Good point Bill. Although I had planned on using doubler, I hadnt given proper thought to the area where I would be cutting.
Top
 Profile Personal album  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 2 of 2
  [ 17 posts ]  Go to page Previous  1, 2

Board index » Thorp T-18 » Fuselage & Empennage

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

[ Time : 0.294s | 10 Queries | GZIP : On ]