| Thorp Air Command - T18.net http://t18.net/thorpforum/ |
|
| N30WW Update http://t18.net/thorpforum/viewtopic.php?f=2&t=6572 |
Page 1 of 1 |
| Author: | Bill Williams [ Sun Apr 17, 2011 5:09 pm ] |
| Post subject: | N30WW Update |
Spent last week working on the damage to the fuselage. I made new skins and three bulheads thatwere damaged. Bob and I riveted the side skins and two bulkheads today. Will finish up the last bulkhead tommorow , then on to the fin and stabilator. Image Insert:  Put File Caption Here |
|
| Author: | Bill Williams [ Fri Apr 22, 2011 3:05 pm ] |
| Post subject: | N30WW Update |
Made a little progress this week, played with the Doc for a couple of days and he put me behind schedule, but the news was good. I manage to cutout and dimple the fin this week. I primed it today and will try and get it riveted together over the weekend. Then on to the horizontal stab. Image Insert:  |
|
| Author: | Rich Brazell [ Fri Apr 22, 2011 4:36 pm ] |
| Post subject: | N30WW Update |
This where experience triumphs over beauty. I would be hard pressed to get even 1/4 of this done ! RB |
|
| Author: | Bill Williams [ Mon Apr 25, 2011 4:16 am ] |
| Post subject: | N30WW Update |
Got the fin riveted up over the weekend, now on to the horizontal stabilizer rebuild. |
|
| Author: | fytrplt [ Mon Apr 25, 2011 10:41 am ] |
| Post subject: | N30WW Update |
Keep some notes on riveting sequence. We will need them for the next project. |
|
| Author: | Bill Williams [ Tue Apr 26, 2011 2:12 pm ] |
| Post subject: | N30WW Update |
Felt pretty good today and managed to cut out and cleco the horizontal skin. Need to clean up and dimple and make a tip. Image Insert:  Put File Caption Here |
|
| Author: | James Grahn [ Wed Apr 27, 2011 1:39 pm ] |
| Post subject: | N30WW Update |
Billy, You are a regular production factory. I guess we need to drop more trucks on you!!! |
|
| Author: | Bill Williams [ Sun May 01, 2011 5:25 pm ] |
| Post subject: | N30WW Update |
Finished riveting the horizontal and started fitting the tip. Will get that done tomorrow. Need to connect the trim motor and fine tune the control surfaces. Prime and paint next.....6 weeks until Elizabeth City. Image Insert:  N30WW horizontal |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|