Should be shown in every sheet metal class and A & P class !
RB
| Thorp Air Command - T18.net http://t18.net/thorpforum/ |
|
| Riveting http://t18.net/thorpforum/viewtopic.php?f=29&t=7576 |
Page 1 of 1 |
| Author: | jrevens [ Wed Apr 30, 2014 5:42 pm ] |
| Post subject: | Riveting |
I found this old Disney movie about aircraft riveting of all things. Kind of interesting... I imagine it's from sometime in the 40's. |
|
| Author: | Pacer 20 [ Wed Apr 30, 2014 6:40 pm ] |
| Post subject: | Re: Riveting |
Old movie, old school but now in 2014 it's the same way we install the flush rivet. |
|
| Author: | fytrplt [ Wed Apr 30, 2014 7:29 pm ] |
| Post subject: | Re: Riveting |
That, my children, is how it's done! |
|
| Author: | Rich Brazell [ Wed Apr 30, 2014 7:46 pm ] |
| Post subject: | Re: Riveting |
Should be shown in every sheet metal class and A & P class ! RB
|
|
| Author: | James Grahn [ Thu May 01, 2014 5:19 pm ] |
| Post subject: | Re: Riveting |
I like it. I never heard the bottom of a dimpled sheet was 110 degrees. Love learning new stuff. Cubes |
|
| Author: | Rich Brazell [ Thu May 01, 2014 6:30 pm ] |
| Post subject: | Re: Riveting |
I knew my "E" tickets would go to good use some day !  Funding one of the better G rated movies ! BOOM ! The Monorail ride at the "Tragic Kingdom", in 1965 was an "E" ticket and it did not impress me ! I gave up another ride on the Matter Horn !  RB
|
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|