Thorp Air Command - T18.net

Supporting Owners, Builders and Pilots of the Thorp T-18 and its variants.
It is currently Sun Dec 22, 2024 10:37 am

View unanswered posts | View active topics


Board index » Thorp T-18 » Wing

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
Andy475
PostPosted: Sun Mar 15, 2020 11:59 pm 
Jr. Member
Jr. Member

Joined: Sat Aug 05, 2017 11:52 pm
Posts: 50
Is there any guidance on holes in the the aft spar carry through spar (under the seat) in terms of size or spacing from the fuselage side wall? I am currently installing ADSB and need to run cables to the tail. The builder spaced the existing holes about 5 inches from the fuselage sidewall. I'd like to run them inside those holes but do not want to compromise the structure by getting too close the aft spar attachment points. Thoughts?

-Andy
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » Thorp T-18 » Wing

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 4 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron

[ Time : 0.086s | 12 Queries | GZIP : On ]