Its not a quadrant, but this has worked out for me.
MG
| Attachments: |
|
010.JPG [ 701.34 KiB | Viewed 10514 times ] |
| Thorp Air Command - T18.net http://t18.net/thorpforum/ |
|
| how do you secure a throttle quadrant on the left side? http://t18.net/thorpforum/viewtopic.php?f=30&t=7460 |
Page 1 of 1 |
| Author: | Ryan Allen [ Fri Nov 22, 2013 9:55 pm ] |
| Post subject: | how do you secure a throttle quadrant on the left side? |
how do you secure a throttle quadrant to the airframe? I'm thinking about putting in a throttle quadrant, but the only way I can think of securing it (without drilling holes in the longeron) would be to make some sort of cantilevered connection to the panel. |
|
| Author: | mgon [ Fri Nov 22, 2013 10:22 pm ] | ||
| Post subject: | Re: how do you secure a throttle quadrant on the left side? | ||
Its not a quadrant, but this has worked out for me. MG
|
|||
| Author: | Ryan Allen [ Sat Nov 23, 2013 6:16 am ] |
| Post subject: | Re: how do you secure a throttle quadrant on the left side? |
I thought about doing that, but I wanted to try and not drill any new holes in the airframe. I do like to the look of it though. |
|
| Author: | fytrplt [ Sat Nov 23, 2013 7:11 am ] |
| Post subject: | Re: how do you secure a throttle quadrant on the left side? |
I drilled two #10 holes in the longeron. Has worked for 2700 hours. |
|
| Author: | Bill Williams [ Sat Nov 23, 2013 7:24 am ] |
| Post subject: | Re: how do you secure a throttle quadrant on the left side? |
Two #10 holes in the longeron and a short piece of angle to bolt the quadrant-1300 hours |
|
| Author: | Ryan Allen [ Sat Nov 23, 2013 8:09 am ] |
| Post subject: | Re: how do you secure a throttle quadrant on the left side? |
ok, well, I guess I see a trend here. thanks. |
|
| Author: | James Grahn [ Sat Nov 23, 2013 11:21 am ] |
| Post subject: | Re: how do you secure a throttle quadrant on the left side? |
By the way, you can drill into structural parts of the airframe as long as those holes are properly taken care of. Cleaning, deburring, and riveting would be a proper way to take care of it. Cubes Ps don't go wild, tho. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|