Thorp Air Command - T18.net
http://t18.net/thorpforum/

Ign wire holder/standoffs
http://t18.net/thorpforum/viewtopic.php?f=35&t=6437
Page 1 of 1

Author:  Rich Brazell [ Fri Dec 10, 2010 9:36 am ]
Post subject:  Ign wire holder/standoffs

If you need a "cheap" (not cheaply made) ign. wire holder/standoff to organize/protect your wires, try this.

Made from scrap angle and 0.020 sheet.

I used a unibit to drill the holes one size larger than the required hole for the grommet. Round off the corners to make grommet insertion easier. Drill and tap for a 4-40 screw. Cut one side of the grommet to slip over the ign wire. Attach a nut plate for easy attach/removal. Sure beats the high cost of using store bought holders. [8D]

RB
NX115RX

Image Insert:
Image

Put File Caption Here

Author:  N89BJ [ Sat Dec 11, 2010 1:15 am ]
Post subject:  Ign wire holder/standoffs

Great idea. Thanks for sharing.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/