| Thorp Air Command - T18.net http://t18.net/thorpforum/ |
|
| Need P/N for Lord Mount for 160hp 0320 with dynafocal http://t18.net/thorpforum/viewtopic.php?f=35&t=8585 |
Page 1 of 1 |
| Author: | dickwolff [ Mon Jan 25, 2021 8:24 am ] |
| Post subject: | Need P/N for Lord Mount for 160hp 0320 with dynafocal |
Need P/N for Lord rubber mounts for 160hp 0320 with dynafocal engine mount. Any recommendations? Dick CYKM C-GABY |
|
| Author: | Jim Mantyla [ Mon Jan 25, 2021 9:08 am ] |
| Post subject: | Re: Need P/N for Lord Mount for 160hp 0320 with dynafocal |
Dick, I used the heavy duty ones from ACS. Part number 08-03600. Regards, Jim |
|
| Author: | fytrplt [ Tue Jan 26, 2021 7:22 am ] |
| Post subject: | Re: Need P/N for Lord Mount for 160hp 0320 with dynafocal |
Mine are the Barry for Cessna 152 and early Mooney. |
|
| Author: | Tony28031998 [ Fri Feb 02, 2024 5:43 pm ] |
| Post subject: | Re: Need P/N for Lord Mount for 160hp 0320 with dynafocal |
Hello THere! I was wondering if any of you had already the p/n for the hardware to use for the same setup as Dick? I have also a dynafocal o320! Thanks! |
|
| Author: | Ryan Allen [ Fri Feb 02, 2024 6:57 pm ] |
| Post subject: | Re: Need P/N for Lord Mount for 160hp 0320 with dynafocal |
I also use the Barry Mount for the 152 and bought from Aircraft Spruce. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|