Thorp Air Command - T18.net http://t18.net/thorpforum/ |
|
Project with main wing bolts already drilled http://t18.net/thorpforum/viewtopic.php?f=36&t=7954 |
Page 17 of 17 |
Author: | James Grahn [ Sat Oct 08, 2022 8:35 pm ] |
Post subject: | Re: Project with main wing bolts already drilled |
Most guys with carbs use some type of intake scoop to make room. Cubes |
Author: | bfinney [ Sat Oct 08, 2022 10:48 pm ] |
Post subject: | Re: Project with main wing bolts already drilled |
Ryan, my "banjo" air box has about 1" of clearance from the carb to the bottom of the air box. Reference photos above, the last one show the bowl around the carb, according to -782 it is 3" deep, the air box -781 is also 3" deep. My engine seems to breath just fine, the filter is 11" dia x 3" deep. It looks like if you want more than 1" clearance that there is some fiber glass work on the horizon. |
Author: | Rich Brazell [ Sun Oct 09, 2022 2:37 pm ] |
Post subject: | Re: Project with main wing bolts already drilled |
Ryan : Hard to tell from your pics , but my glass scoop appears to be deeper than yours ? I got mine from Mike Archer many years ago and it was actually a two piece part...the scoop and the lower cowl . You had to off set the scoop slightly to fit the carb/filter/carb heat box . Even then it is a tight fit on the sides to get the carb assembly to fit . Eleven years later no problems noted . RB |
Author: | Ryan Allen [ Mon Oct 10, 2022 9:26 am ] |
Post subject: | Re: Project with main wing bolts already drilled |
Thanks Rich, lowering the scoop is another option I hadn't considered. That may be a solution. |
Author: | Rich Brazell [ Mon Oct 10, 2022 9:09 pm ] |
Post subject: | Re: Project with main wing bolts already drilled |
Remember...I am always right at least 50% of the time ! RB |
Page 17 of 17 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |