Thorp Air Command - T18.net http://t18.net/thorpforum/ |
|
Infinity Aerospace Miitary Style Stick Grip http://t18.net/thorpforum/viewtopic.php?f=48&t=7015 |
Page 1 of 2 |
Author: | Rich Brazell [ Fri May 04, 2012 3:30 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Now you tell me ! Just installed two of the Infinity grips. RB |
Author: | Brent Schultz [ Sun May 06, 2012 6:52 am ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Lee, Its just what I need. I will take as we have center throttle on our new Thorp. Brent Schultz N6CM |
Author: | leewwalton [ Sun May 06, 2012 1:15 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Ok Brent it's all yours. |
Author: | Brent Schultz [ Sun May 06, 2012 7:04 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Lee, Where should I send the check Brent |
Author: | leewwalton [ Sun May 06, 2012 7:08 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Here you go Brent ... 5000 Schuler unit E Houston, TX 77007 Is the Teton Ave address ok for you? |
Author: | Brent Schultz [ Wed May 09, 2012 10:55 am ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Lee, I just put check in the mail. Would appreciate you mailing stick grip to me. Send it to: Brent Schultz 6048 East Teton Avenue Orange, CA 92867 Thanks for helping get our Thorp back in the air! Brent |
Author: | leewwalton [ Wed May 09, 2012 11:08 am ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
On the way Brent ... was just waiting to make sure the address was correct. |
Author: | Brent Schultz [ Fri May 18, 2012 4:39 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Lee, I got the stick grip. Thanks!!!! Brent Schultz |
Author: | leewwalton [ Fri May 18, 2012 4:48 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Good deal Brent! Now find a use for all those buttons, switches and trigger! |
Author: | leewwalton [ Fri May 18, 2012 4:51 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Btw you'll need to make a spacer to put that on the 3/4 thorp stick. I used a piece of 1" dia 1/8 wall alum tubing. That brings the 1" grib down to the 3/4" stick. |
Author: | Brent Schultz [ Fri May 18, 2012 5:57 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
I thought the stick hole looked a bit big. That's no problem. We have plenty if metal tubing stock to make the spacer. Did u use that momentary switch on the top to actuate the flaps. We bought the actuator u recommended. Also, what would u use those other two buttons on the right for? Maybe to change comm frequencies or the Garmin GPS? |
Author: | Rich Brazell [ Fri May 18, 2012 7:02 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Go to the Infinity Web page. It has the drawing for the required spacer for our sticks. I had to remove the "blue insulation" from the main wire and solder all the grounds to a common point in order to reduce the number of wires going down the stick and out the bottom. Got this tip from another site ? You can buy the required spacer from Infinity for $15.00. Took me about 15 min. to make mine. When I install electric flaps, I will have one spare switch on the grip. The flap switch is the toggle switch with up/on and mom. down. RB |
Author: | Rich Brazell [ Sun May 20, 2012 3:06 pm ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Don't forget to offset the grip. If you don't put in the twist/offset your wrist will get mighty tired ! Looking straight down from the top of the grip for the pilots side the PTT trigger will be pointing slightly to the co-pilots side. RB |
Author: | fytrplt [ Mon May 21, 2012 6:14 am ] |
Post subject: | Re: Infinity Aerospace Miitary Style Stick Grip |
Unless the throttle is on the left, FIGHTER style! |
Page 1 of 2 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |