Thorp Air Command - T18.net
http://t18.net/thorpforum/

WTB Wood Prop
http://t18.net/thorpforum/viewtopic.php?f=48&t=7108		 Page 1 of 1
Author:  mgon [ Sat Sep 15, 2012 12:40 pm ]
Post subject:  WTB Wood Prop
Have,
Lyc. 160 HP
3/8 Bolts
Running Sensenich 68/84
Looking for better cruise

MG
Author:  Fraser MacPhee [ Mon Sep 17, 2012 11:52 am ]
Post subject:  Re: WTB Wood Prop
A little vague there MG - what kind of static and full power flying RPMs are you getting with your engine prop combo? - compressions all good on motor? - you may have an optimum (or close to) combination, but the rigging is outawumpus, or there are places to fair (wheel pant brake cuffs, wing root fairings, tightness around the exhaust/cowl opening, etc) that will provide more speed. I have a (close to) 160 HP and a C/S and get 150 Knots in the 24 squared range and I know I could gain 8-10 more knots putting the brake cuffs and tightening up the cowl/exhaust area - my motor mounts are sagging down and to the right (like Rich) a degree or so and that is causing the plane to fly a half bubble off center (like me) - another knot or two when they get replaced this winter.

Speed is not just the engine and prop combo. In fact, if you want more speed, put your mother in law (sedated and within CG limits of course) in the baggage compartment when you fly and trim the tail up.........trust me
Author:  Rich Brazell [ Mon Sep 17, 2012 3:22 pm ]
Post subject:  Re: WTB Wood Prop
I thought you had a Trunk Monkey for W & B ? :o Sooner or later we all sag !
Author:  mgon [ Mon Sep 17, 2012 3:44 pm ]
Post subject:  WTB Wood Prop
Vague - not at all

Have,

160 HP
3/8 Bolts
Sensinich 68/84
looking for a replacement, would
like better cruise.

Prop has a few hrs on it, came off
an RV6, bought it used.
Looking to buy a used, in good shape
prop with equal or preferred better cruise.
Will go new if I can't find used.
Thanks
MG
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/