Thorp Air Command - T18.net

Supporting Owners, Builders and Pilots of the Thorp T-18 and its variants.
It is currently Sun Dec 22, 2024 3:42 am

View unanswered posts | View active topics


Board index » Other Stuff » Vendors/Builder Resources

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Rich Brazell
PostPosted: Mon Feb 08, 2010 5:48 pm 
Hero Member
Hero Member

Joined: Wed Oct 21, 2009 12:33 pm
Posts: 3108
Images: 64
Location: Jamul, CA (San Diego area)
Enco.com Go to the outlet section. 48 inch bench top bending brake. 48% off and free shipping. Shipping charges alone are more than $150.00. Model #130-5220. For some reason the operators manual is not the same as the unit shipped (ROC) ? Adjusting the top leaf for radius bends is not that depicted in the manual. If you look at the unit closely, there is an adjustment at the rear that uses a set screw. When Lee changed over to the "new" Forum provider, this listing was "erased?"

RB


Last edited by Anonymous on Mon Feb 08, 2010 5:48 pm, edited 1 time in total.

Top
 Profile Personal album  
 
Rich Brazell
PostPosted: Mon Feb 08, 2010 9:52 pm 
Hero Member
Hero Member

Joined: Wed Oct 21, 2009 12:33 pm
Posts: 3108
Images: 64
Location: Jamul, CA (San Diego area)
Yes they were,


Last edited by Anonymous on Mon Feb 08, 2010 9:52 pm, edited 1 time in total.

Top
 Profile Personal album  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Other Stuff » Vendors/Builder Resources

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

[ Time : 0.095s | 11 Queries | GZIP : On ]