Thorp Air Command - T18.net

Supporting Owners, Builders and Pilots of the Thorp T-18 and its variants.
It is currently Sun Dec 22, 2024 1:51 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 12 posts ] 
Author Message
dan
 Post subject: Cubes Race Rocket
PostPosted: Sun Mar 17, 2013 8:57 pm 
Sr. Member
Sr. Member

Joined: Wed Oct 21, 2009 9:30 am
Posts: 898
Images: 0
Location: USA
Cubes, went over to Mike&Frankies today and looked at the left turn Cloud Burner. It looks GOOOOOOOOOOD! Mike a I discussed the Locks for the gear give him a call. I like the retracts, The design is a good one and if I had any fortitude left I would be building me a new center section so I could have them also!!! Good job!!!! They look like they are lighter than the standard Gear, Even if they were not retractable they are super looking just as non retracts!!! Dan


Top
 Profile  
 
James Grahn
 Post subject: Re: Cubes Race Rocket
PostPosted: Tue Mar 26, 2013 2:44 pm 
Hero Member
Hero Member

Joined: Sat Oct 24, 2009 7:16 pm
Posts: 1462
Images: 0
Location: USA
Sorry, I've been off the web for a while. Thanks for the comments, Danny. It's coming along. My engine was delivered last week. It's a GM performance parts ZZ 383 crate engine. 420hp should be enough. I will be out there tomorrow working on the engine mount.


Top
 Profile Personal album  
 
dan
 Post subject: Re: Cubes Race Rocket
PostPosted: Tue Mar 26, 2013 10:43 pm 
Sr. Member
Sr. Member

Joined: Wed Oct 21, 2009 9:30 am
Posts: 898
Images: 0
Location: USA
There going to have to anchor the pylons a little better..........


Top
 Profile  
 
Rich Brazell
 Post subject: Re: Cubes Race Rocket
PostPosted: Wed Mar 27, 2013 9:51 pm 
Hero Member
Hero Member

Joined: Wed Oct 21, 2009 12:33 pm
Posts: 3108
Images: 64
Location: Jamul, CA (San Diego area)
Let me see if I can get some anchor chain from the USS Ronald Regan to tie down that beast for your engine run ! BOOM !

RB O0


Top
 Profile Personal album  
 
SHIPCHIEF
 Post subject: Re: Cubes Race Rocket
PostPosted: Thu Mar 28, 2013 10:00 am 
Sr. Member
Sr. Member

Joined: Tue Nov 29, 2011 9:05 pm
Posts: 471
Location: USA
Lets see a picture of this mythical beast!!?

_________________
Scott Emery
EAA Chapter 326
T-18 N18TE


Top
 Profile  
 
stevehawley
 Post subject: Re: Cubes Race Rocket
PostPosted: Thu Mar 28, 2013 3:44 pm 
Jr. Member
Jr. Member

Joined: Tue Mar 02, 2010 2:30 pm
Posts: 86
Location: USA
This sounds great but I doubt if it will do what a homebuilt did for me that I built back in the late 50s and early 60s. This is the truth, but hard to believe! From the time I advanced the throttle, from a standing start I could climb through 10,000 feet in less that 18 seconds. It wasn't my T-18.
Steve Hawley


Top
 Profile  
 
dan
 Post subject: Re: Cubes Race Rocket
PostPosted: Thu Mar 28, 2013 8:28 pm 
Sr. Member
Sr. Member

Joined: Wed Oct 21, 2009 9:30 am
Posts: 898
Images: 0
Location: USA
Ok Steve, I believe you, I can see you pulling a stunt like that in something that scorched the tarmack when you throttled up. Now then, tell us how bad you violated every rule in the book and what ya did it in. Come on, spit it out, my curiosity is going to eat me up here till I find out....Dan


Top
 Profile  
 
stevehawley
 Post subject: Re: Cubes Race Rocket
PostPosted: Fri Mar 29, 2013 4:54 am 
Jr. Member
Jr. Member

Joined: Tue Mar 02, 2010 2:30 pm
Posts: 86
Location: USA
Thanks for believing me Dan. It is very true. Back in 1976 the company I worked for sent me to Granite, Colorado and. I based my Stits Playboy with a 125 Lycoming GPU at Leadville. I only had to climb 82 feet to pass through 10,000'. The little plane had no electrical system and was light as a feather. Things were different then. The day I flew it I had only spent $670.00 in cash. Can't do that these days. By the way,
The plane is still flying near Nashville.
Steve


Top
 Profile  
 
dan
 Post subject: Re: Cubes Race Rocket
PostPosted: Fri Mar 29, 2013 8:25 am 
Sr. Member
Sr. Member

Joined: Wed Oct 21, 2009 9:30 am
Posts: 898
Images: 0
Location: USA
Steve, I am not surprised at all that the plane is still flying, only had to go 80 somthing feet to get through 10,000 ft, Ya onery cuss I thought you had built a rocket.........Dan


Top
 Profile  
 
James Grahn
 Post subject: Re: Cubes Race Rocket
PostPosted: Sat Mar 30, 2013 8:18 pm 
Hero Member
Hero Member

Joined: Sat Oct 24, 2009 7:16 pm
Posts: 1462
Images: 0
Location: USA
If I could figure out how to put pictures on this iPad, I could post some. The only ones I have at the moment are the ones Lee put in the newsletter.
Cubes


Top
 Profile Personal album  
 
Rich Brazell
 Post subject: Re: Cubes Race Rocket
PostPosted: Sat Mar 30, 2013 9:46 pm 
Hero Member
Hero Member

Joined: Wed Oct 21, 2009 12:33 pm
Posts: 3108
Images: 64
Location: Jamul, CA (San Diego area)
Steve: With that kind of performance data it is no wonder Defense Contractors get a winning bid ! :o

RB O0


Top
 Profile Personal album  
 
stevehawley
 Post subject: Re: Cubes Race Rocket
PostPosted: Sun Mar 31, 2013 4:21 am 
Jr. Member
Jr. Member

Joined: Tue Mar 02, 2010 2:30 pm
Posts: 86
Location: USA
Rich, I worked for a large contractor for 25 years and worked on contracts with the Corps of Engineers, Bureau of Reclamation, and U. S. Navy, among others. It is scary! If a contractor is dishonest (we were not) it is unbleavable how easy it is to screw the government.
Steve Hawley


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

[ Time : 0.106s | 10 Queries | GZIP : On ]